Bioenno 6 Amp-Hour Battery
This is a Lithium-Ferrous-Phosphate (LiFePO4) battery. It uses state of the art chemistry resulting in batteries that are both physically and thermally extremely stable. Importantly they are intrinsically safer than other lithium chemistries because of their strong ultra-stable Fe-PO bond. These batteries offer many advantages relative to sealed lead acid batteries (SLA). Here are five top advantages:
· First, they cannot sulfate, leak, or vent, like an SLA
· Second, they weigh about 60% less, and are half the volume, of an SLA
· Third, charge and discharge life cycles
exceed 2000, compared with around 300 for SLA’s
· Fourth, built in protection for
overcharging and discharging and cell balancing
· Fifth, 100% of their Amp-Hour capacity is
available, whereas about 60% for SLA’s
Bioenno batteries are nominally “12” volts. When fully charged they measure 13.8 volts. During discharge the voltage will drop very slowly until around 12 volts at 90% discharged, 11.5 volts at 95% discharged, and turning off at 11.0 volts when the full amp-hour rating is reached.
This is a 6 Amp-Hour battery. It is outfitted with a Powerpole connector
and a special DC socket to permit connection to a convenient charger. This
makes it is ideal for powering radio transmitters for amateur, or general
communication It can power a 20 watt transceiver radio for over 9 hours. Click "Charger" above to add the 2 Amp charger, BPC-1502, for $22. Shipping is by US Postal, PARCEL POST, Ground service.
Type: Lithium-Ferrous-Phosphate. LiFePO4.
Nominal Voltage: 12 Volts
Maximum Charged Quiescent Voltage: 13.8 Volts
Minimum Voltage: 11.0 Volts at cutoff
Float Voltage: 14.6 volts
Capacity: 6 Ampere Hours
Maximum Discharge Current: 12 Amperes continuously
Output Connector: 6 inch wire
with Red, Black Powerpole
Charging Connector: 6 inch wire with a DC socket (Note: This wire connects to the output wire)
Size: 5.4 x 2.8 x 2.5 inches
Weight: 1.7 lbs.
Warrantee: 2 years from purchase date